Switch it on by pressing the power button on the right side.
Plug in the USB C cable into the Quest 2 and into your PC or Laptop you downloaded the mod onto.
The cable which comes with the Quest 2 will work perfectly.
You must use a cable that is for charging and data, if you use a charging only cable it won’t work.
There may be a notification asking you to Allow access to data
.
This will let your PC or Laptop access your Quest 2's files.
Select Allow
Do not click Deny or Don’t show again
If your Quest 2 is in Developer mode, you will not be able to access your Quest 2 internal storage this way. In Developer mode you can only access the internal storage over ADB. You will need to use Side Quest to transfer the files.
You must disable Developer mode, reboot your Quest 2 and plug in your cable again and it should prompt you to Allow access to data
.
You dont need to wear the headset for the next part.
On your PC or Laptop which you plugged the Quest 2 into, open File Explorer
and go to This PC
. Where you would normally see your hard drives.
You can do this many ways in Windows.
This PC
. Click the This PC
icon.This PC
on the left side of the windowWindows Key
AND E
at the same time. Click This PC
on the left side of the windowIn This PC
check you have the Quest 2
drive appearing.
The folder should be here: This PC\Quest 2\Internal shared storage\Android\data\com.Warpfrog.BladeAndSorcery\files\Logs
There are two ways to get to the folder.
Open up the Quest 2
drive by double clicking it.
Then you can go through each of the folders by double clicking on them:
Internal shared storage
Android
data
com.Warpfrog.BladeAndSorcery
files
Logs
Inside the Log folder is sometimes two files, Player.log
and Player-prev.log
. Sometimes they may just appear as Player
and Player-prev
depending on your Windows settings.
You can copy the log file onto your PC by dragging and dropping it from the Logs
folder Window to your desktop, where you can then send it on discord if needed.